Electrolux FAC124P1A Instrucciones de operaciones descargar pdf (Pagina 65)

Section 4 Component Teardown

4-5

Figure 4-8. FAM Series Heater Equipped Model

Left Bulkhead Partition (Heater Equipped Models)

The electrical component connections to the control

board are located in the control box located in the upper

left hand corner of the unit. The left bulkhead partition

must be removed first to access all the components in

the control box.

To remove the left bulkhead partition:

1. Disconnect power supply from unit.

2. Remove the front panel assembly. Pull the unit from

the cabinet wrapper/sleeve. Remove the blower

scroll front cover.

3. Pull thermistor from retainer on copper tubing.

4. Remove thermistor from retainer on evaporator.

5. Extract the screws on the left side of the bulkhead

partition. (See Figure 4-8) This will include the screw

securing terminal block to the left bulkhead partition.

6. Extract the screw from behind left bulkhead partition

and the screw securing the left bulkhead partition to

the top of the front partition. (See Figure 4-8)

7. Cut wire harness retaining straps, then pull apart to

allow access to the wire harness connections to the

electrical components.

8. The control board is mounted with a metal bracket

that slides over the top of the left bulkhead partition.

Carefully pull the control board out from inside

the compartment. Disconnect compressor and

condenser fan wire leads from control board,

capacitors and terminal blocks.

9. Disconnect red and white heater wire leads from

capacitor and terminal block.

10. Carefully pull the left bulkhead partition with the

electrical components off of the unit.

Power Cord Removal

To remove the power cord:

1. Disconnect power supply from unit.

2. Pull the unit from the cabinet wrapper/sleeve.

Remove the blower scroll front cover and left

bulkhead partition. Cut retaining straps securing the

wiring harness in the control box area.

3. Disconnect black wire from side 1 and white wire

from side 2 of terminal block XT1. (See Figure 4-10)

4. Extract the ground screw that secures the power

cord ground wire to the control box. (See Figure 4-9)

5. Cut retaining strap securing the power cord and

thermistor wires together, then remove power cord.

Screws

Figure 4-9. FAM Series No Heat

Screw

Power Cord

Power Cord Entering

Compartment

Screw

Screws

Transformer

XT1 Terminal

Block

Capacitor

Fan

Motor

Control Board

Figure 4-10. Control Box FAS Series No Heat

Wires omitted for clarity

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 139 140

Comentarios a estos manuales

Sin comentarios

Electrolux FAC124P1A Instrucciones de operaciones Pagina 65

Comentarios a estos manuales

Relacionado con productos y manuales para Acondicionadores de aire del sistema de división Electrolux FAC124P1A