Electrolux FAC124P1A Instrucciones de operaciones descargar pdf (Pagina 7)

Room Air Conditioners manufactured after August 1st, 2004 are equipped with a new industry

regulated power cord with either of the following in the plug-head or in line:

LCDI: Leakage Current Detection Interrupter

AFCI: Arc-Fault Circuit Interrupter.

All Frigidaire products have an LCDI located in the plug head or in-line.

Section 1 Basic Information

1-5

WARNING

This service manual is intended for use by persons having electrical and mechanical training and a

level of knowledge of these subjects generally considered acceptable in the appliance repair trade.

Electrolux home products cannot be responsible, nor assume any liability, for injury or damage of

any kind arising from the use of this manual.

WARNING

The power supply cord contains a current device that senses damage to the power cord. To test your

power supply cord do the following:

1. Plug in the Air Conditioner.

2. The power supply cord will have TWO buttons on the plug head. Press the TEST button. You will

notice a click as the RESET button pops out.

3. Press the RESET button. Again you will notice a click as the button engages.

4. The power supply cord is now supplying electricity to the unit. (On some products this is also

indicated by a light on the plug head).

Notes

1. Do not use this device to turn the unit on or off.

2. Always make sure the RESET button is pushed in for correct operation.

3. The power supply cord must be replaced if it fails to reset when either the TEST button is pushed, or

it cannot be reset. A new one can be obtained from the product manufacturer.

4. If power supply cord is damaged, it CANNOT be repaired, it MUST be replaced by one obtained from

the product manufacturer.

WARNING

Plug in &

Press RESET

NOTE: Some plugs have the

buttons on the side.

RESET

TEST

1 2 3 4 5 6 7 8 9 10 11 12 ... 139 140

Sin comentarios

Electrolux FAC124P1A Instrucciones de operaciones Pagina 7